Nissan Murano: Inspection and Adjustment / Additional Service When Removing Battery Negative Terminal
Work Procedure
SYSTEM INITIALIZATION
Perform system initialization. Refer to Work Procedure.
>>
GO TO 2.
MEMORY STORAGE
Perform memory storage. Refer to Work Procedure.
>>
GO TO 3.
INTELLIGENT KEY INTERLOCK STORAGE
Perform Intelligent Key interlock storage. Refer to Work Procedure.
>>
GO TO 4.
SYSTEM SETTING
Perform system setting. Refer to Work Procedure.
>>
Inspection End.
Description
Each function is reset to the following condition when the driver seat control unit is replaced. Function Condition Procedure
Memory (Seat, steering column, door mirror)
Erased
Perform storing
Entry/exit assist
ON
Perform initialization
Set slide amount*1
Linking a key fob to meter display
Erased
Perform initialization
Perform storing
*1: Default value is 40 mm...
Other information:
Instrument Panel
12V OUTLETS
The power outlets are for powering electrical
accessories such as cellular telephones.
They are rated at 12 volt, 120W (10A)
maximum.
The vehicle’s power outlets are powered
only when the ignition switch is in the ACC
(if so equipped) or ON position...
System Description
SYSTEM DIAGRAMAround View Monitor Control Unit Input Signal (CAN Communication)Transmit unitSignal name
ABS actuator and electrical unit (Control unit)
Wheel speed signal
AV control unit
Camera switch signal
BCM
Door switches state signal
Combination meter
Setting change request signal
Hand brake switch signal
IPDM E/R
Battery voltage signal
Sonar control unit
Sonar detection display request signal
Steering angle sensor
Steering angle signal
TCM
Transmission range indication signal
DESCRIPTION
This system is equipped with wide-angle cameras on the front, rear and right and left door mirrors...