Nissan Murano: System / Signal Buffer System
Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / System Description / System / Signal Buffer System
SYSTEM DIAGRAM
OUTLINE
BCM has the signal transmission function that outputs/transmits each input/received signal to each unit.
Signal transmission function list
| Signal name | Input | Output | Description |
|---|---|---|---|
| Push-button ignition switch signal | Push-button ignition switch | BCM | Transmits the push-button ignition switch signal to the BCM. |
| Push-button ignition switch ON signal | BCM | IPDM E/R (CAN) | Transmits the push-button ignition switch signal via CAN communication. |
| Door switch signal | Door switch (ALL) | BCM | Transmits the door switch signal to the BCM. |
| Door switch signal | BCM | Each unit (CAN) | Transmits the door switch signal via CAN communication. |
Combination Switch Reading System
System Description
SYSTEM DIAGRAMOUTLINE
BCM reads the status of the combination switch (light, turn signal, wiper and washer) and recognizes the status of each switch...
Power Consumption Control System
System Description
SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNALMajor signal transmission between each unit via communication lines is shown in the following table: Component parts Signal description
IPDM E/R
Each unit transmits the sleep-ready signal (ready) to BCM when all of the CAN sleep conditions are fulfilled...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Workflow
Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. REPRODUCE THE MALFUNCTION Reproduce the malfunction on the Nissan Murano vehicle that the customer describes...
Nissan Murano (Z52) 2015-2024 Service Manual: P0746 Pressure Control Solenoid a
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0746 PC SOLENOID A (Pressure Control Solenoid A Performance/Stuck Off) 1 Diagnosis condition When all of the following conditions are satisfied: Engine speed: More than 600 rpm Primary pulley speed: More than 450 rpm Idle is not being detected...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- How to enable/disable the LDW system
- High Beam Assist (if so equipped)
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
Copyright © 2026 www.nimurano.com