Nissan Murano: Driveline :: Rear Propeller Shaft: C-Cvj-C / Service Data and Specifications (sds). Service Data and Specifications (sds)

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Driveline :: Rear Propeller Shaft: C-Cvj-C / Service Data and Specifications (sds). Service Data and Specifications (sds)

General Specifications

Applied model	Axle	AWD
	Engine	VQ35DE
	Transaxle	CVT
Propeller shaft model		C-CVJ-C
Number of joints		3
Joint type	1st joint	Universal (Shell type)
	2nd joint	CVJ type
	3rd joint	Universal (Shell type)
Coupling method	Transfer side	Flange type
Coupling method	Rear final drive side	Flange type
Shaft length	1st (Spider to CVJ joint center)	1265 mm (49.80 in)
Shaft length	2nd (CVJ joint center to spider)	1024 mm (40.31 in)
Shaft outer diameter	1st shaft	75 mm (2.95 in)
Shaft outer diameter	2nd shaft	80 mm (3.15 in)

Propeller Shaft Runout

Unit: mm (in)

Item		Standard
Propeller shaft runout		0.8 (0.031) or less

Journal Axial Play

Unit: mm (in)

Item		Standard
Journal axial play		0 (0)

Removal and Installation. Rear Propeller Shaft

Exploded View Propeller shaft assembly Center bearing mounting bracket (upper) Clip Center bearing mounting bracket (lower) : Nissan Murano Vehicle front : N·m (kg-m, ft-lb) : Always replace after every disassembly...

Driveline :: Rear Final Drive: R145

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Intelligent Key System/engine Start Function

System Description SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNAL CHART Component Signal description ECM Mainly transmits the following signal to BCM and combination meter via CAN communication. Engine status signal Mainly receives the following signal from BCM via CAN communication...

Nissan Murano (Z52) 2015-2024 Service Manual: Wiper and Washer Fuse

Diagnosis Procedure CHECK FUSES Check that the following fuses are not blown: Component Location Fuse No. Capacity Front wiper motor IPDM E/R 48 30 A Front and rear washer motor IPDM E/R 47 10 A Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit...