Nissan Murano: Seat belts / Seat belt maintenance
- To clean the seat belt webbing, apply
a mild soap solution or any solution recommended
for cleaning upholstery or
carpet.Then wipe with a cloth and allow
the seat belts to dry in the shade.Do not
allow the seat belts to retract until they
are completely dry.
- If dirt builds up in the shoulder belt
guide of the seat belt anchors, the
seat belts may retract slowly. Wipe the
shoulder belt guide with a clean, dry
cloth.
- Periodically check to see that the seat
belt and the metal components, such
as buckles, tongues, retractors, flexible
wires and anchors, work properly. If
loose parts, deterioration, cuts or other
damage on the webbing is found, the
entire seat belt assembly should be replaced.
If, because of body size or driving position, it
is not possible to properly fit the
lap/shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase...
WARNING
Do not allow children to play with the
seat belts. Most seating positions are
equipped with Automatic Locking Retractor
(ALR) mode seat belts...
Other information:
A chime sounds under the following conditions
and the control is automatically canceled:
When the vehicle slows down more
than 8 mph (13 km/h) below the set
speed
Whenthe shift lever is not in theD(Drive)
or manual shift mode
When the parking brake is applied
When the VDC operates (including the
traction control system)
When a wheel slips
When the system is not operating properly,
the chime sounds and the color of the
cruise indicator will change to orange...
CAMERA button
WARNING
Failure to follow the warnings and instructions
for the proper use of the
Intelligent Around View Monitor system
could result in serious injury or
death.
The Intelligent AroundView Monitor is
a convenience feature and is not a
substitute for proper vehicle operation
because it has areas where objects
cannot be viewed...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more