Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Roof :: Basic Inspection

Sunshade Motor Assembly

Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No. (Wire color) Description Condition Voltage (Approx.) + - Signal name Input/Output 1 (R) Ground Battery Input Supplies power to sunshade motor...

Diagnosis and Repair Workflow

Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0125 Ect Sensor

DTC Description DTC DETECTION LOGIC Voltage sent to ECM from the sensor is not practical, even when some time has passed after starting the engine. Engine coolant temperature is insufficient for closed loop fuel control. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0125 ECT SENSOR (Insufficient coolant temperature for closed loop fuel control) 1 Diagnosis condition — Signal (terminal) Voltage signal transmitted from engine coolant temperature sensor to ECM Threshold Voltage sent to ECM from the sensor is not practical, even when some time has passed after starting the engine Diagnosis delay time — 2 Diagnosis condition — Signal (terminal) Voltage signal transmitted from engine coolant temperature sensor to ECM Threshold Engine coolant temperature is insufficient for closed loop fuel control Diagnosis delay time — POSSIBLE CAUSE Harness and connectors (High resistance in the circuit) Engine coolant temperature sensor Thermostat FAIL-SAFENot applicable DTC Confirmation Procedure CHECK DTC PRIORITY If DTC P00125 is displayed with DTC P0116, P0117 or P0118, first perform the trouble diagnosis for DTC P0116, P0117 or P0118...

Nissan Murano (Z52) 2015-2024 Service Manual: Audio Unit

Exploded View 1. Audio unit bracket (RH) 2. Audio unit 3. Audio unit bracket (LH) 4. A/C auto amp. Removal and Installation REMOVALCAUTION: Before disconnecting the audio unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...