Nissan Murano: In case of emergency / Push starting

Nissan Murano (Z52) 2015-2024 Owners Manual / In case of emergency / Push starting

CAUTION

Continuously Variable Transmission (CVT) models cannot be push-started or tow-started. Attempting to do so may cause transmission damage.
Do not push start this vehicle. The three-way catalyst may be damaged.

Jump starting

To start your engine with a booster battery, the instructions and precautions below must be followed. WARNING If done incorrectly, jump starting can lead to a battery explosion, resulting in severe injury or death...

If your vehicle overheats

WARNING Donot continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire. To avoid the danger of being scalded, never remove the radiator or coolant reservoir cap while the engine is still hot...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: System temporarily unavailable

Condition A: In the following conditions, the AEB with Pedestrian Detection system warning light blinks and the system will be turned off automatically: The radar sensor picks up interference from another radar source. The camera area of the windshield is misted or frozen...

Nissan Murano (Z52) 2015-2024 Service Manual: P0112 Iat Sensor

DTC Description DTC DETECTION LOGIC An excessively low voltage from the sensor is sent to ECM. An excessively high voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0112 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively low voltage from the sensor is sent to ECM Diagnosis delay time — P0113 IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit high bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Voltage signal transmitted from intake air temperature sensor to ECM Threshold An excessively high voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0112 Harness and connectors (The sensor circuit is open or shorted...