Nissan Murano: Audio, Visual & Navigation System :: Display Audio System - With 8" Color Display / Precaution. Precautions

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Display Audio System - With 8" Color Display / Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.

Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.

WARNING:

Always observe the following items for preventing accidental activation:

  • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.

  • Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.

  • Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

Always observe the following items for preventing accidental activation:

  • When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.

  • When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.

Precaution for Harness Repair

AV COMMUNICATION SYSTEM

  • Solder the repaired parts, and wrap with tape. [Frays of twisted line must be within 110 mm (4.33 in).]

  • Do not perform bypass wire connections for the repair parts. (The spliced wire will become separated and the characteristics of twisted line will be lost.)

Precautions for Work
  • When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth.

  • When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a shop cloth or vinyl tape to protect it.

  • Protect the removed parts with a shop cloth and prevent them from being dropped.

  • Replace a deformed or damaged clip.

  • If a part is specified as a non-reusable part, always replace it with a new one.

  • Be sure to tighten bolts and nuts securely to the specified torque.

  • After installation is complete, be sure to check that each part works properly.

  • Follow the steps below to clean components:

    • Water soluble dirt:

      1. Dip a soft cloth into lukewarm water, wring the water out of the cloth and wipe the dirty area.

      2. Then rub with a soft, dry cloth.

    • Oily dirt:

      1. Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%) and wipe the dirty area.

      2. Then dip a cloth into fresh water, wring the water out of the cloth and wipe the detergent off.

      3. Then rub with a soft, dry cloth.

    • Do not use organic solvent such as thinner, benzene, alcohol or gasoline.

    • For genuine leather seats, use a genuine leather seat cleaner.

    Audio, Visual & Navigation System :: Display Audio System - With 8" Color Display

    ..

    Preparation. Preparation

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: U0433-83 Dist Sen Can Circ 2


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition U0433-83 ICC SENSOR CAN CIRC 2 [Distance sensor (ICC sensor) CAN circuit 2] Diagnosis condition When Ignition switch is ON. Signal (terminal) — Threshold ADAS control unit received invalid data from distance sensor (ICC sensor) via ITS communication Diagnosis delay time 1 second or less POSSIBLE CAUSEDistance sensor (ICC sensor)ADAS control unitFAIL-SAFEThe following systems are canceled: Intelligent Cruise Control (ICC) Automatic Emergency Braking (AEB) Automatic Emergency Braking (AEB) with pedestrian detection Intelligent Forward Collision Warning (I-FCW) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “U0433-83” is displayed with DTC “U1000–01”, first diagnose the DTC “U1000–01”...

    Nissan Murano (Z52) 2015-2024 Owners Manual: Outside mirrors


    WARNING Do not adjust the mirrors while driving. You could lose control of your vehicle and cause an accident. Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident...

    Categories

    Front manual seat adjustment (if so equipped)

    Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.

    Forward and backward

    Nissan Murano. Front manual seat adjustment (if so equipped)

    read more

     
    Copyright © 2026 www.nimurano.com