Nissan Murano: Power Window Control System :: Symptom Diagnosis / Power Windows Do Not Operate with Main Power Window and Door Lock/unlock Switch
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY AND GROUND CIRCUIT
Check main power window and door lock/unlock switch power supply and ground circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>GO TO 1.
Front Lh Power Window Alone Does Not Operate
Diagnosis Procedure
CHECK FRONT POWER WINDOW MOTOR LH
Check front power window motor LH.
Refer to Component Function Check .
Is the inspection result normal?
YES>>
GO TO 2...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Repairing Material
Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Murano vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available urethane foam for sealant (foam material) repair of material used on vehicle...
Nissan Murano (Z52) 2015-2024 Owners Manual: Locking with key
To lock or unlock the vehicle, turn the key as shown. Manual To lock a door, turn the key toward the front of the vehicle . To unlock a door, turn the key toward the rear . Power (if so equipped) The power door lock system allows you to lock or unlock all doors at the same time...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Memory storage function (key-link)
- Shift lock release
- New on site
- Most important about car
Fuel gauge
The gauge indicates the approximate fuel level in the tank.
The gauge may move slightly during braking, turning, acceleration, or going up or down hills.
The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.
