Nissan Murano: Dtc/circuit Diagnosis / Power Supply and Ground Circuit (side Radar Lh)

U1010-49 Control Unit (can)

DTC Description DESCRIPTIONCAN controller controls the communication of ITS communication signal and the error detection.DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1010-49 CONTROL UNIT (CAN) [Control unit (CAN)] Diagnosis condition When ignition switch is ON...

Power Supply and Ground Circuit (lane Camera Unit)

Work Procedure CHECK FUSES Check that the following fuse is not blown. Signal name Fuse No. Ignition power supply 29(10A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0794 Intermediate Speed Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0794 INTERMEDIATE SPEED SENSOR A (Intermediate Shaft Speed Sensor "A" Circuit Intermittent) Diagnosis condition TCM power supply voltage: More than 11 V Signal — Threshold Primary pulley speed: more than 11820 rpm Diagnosis delay time Maintained 2 seconds POSSIBLE CAUSE Harness or connector (Primary speed sensor circuit is open or shorted) Primary speed sensor TCM FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed Manual mode is not activated Confirmation Procedure DTC CONFIRMATION PROCEDURECAUTION: Always drive vehicle at a safe speed...

Nissan Murano (Z52) 2015-2024 Service Manual: B1341 Head Unit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1341–16 Head unit (Audio unit) [VB–LOW] Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold – Diagnosis delay time 30 seconds or more B1341–17 [VB–HIGH] Diagnosis condition When ignition switch is ON...