Nissan Murano: Automatic Drive Positioner :: Dtc/circuit Diagnosis / Power Seat Switch Lh Ground Circuit
CHECK POWER SEAT SWITCH LH GROUND CIRCUIT
-
Ignition switch OFF.
-
Disconnect power seat switch LH.
-
Check continuity between power seat switch LH connector and ground.
Power seat switch LH Ground Continuity Connector Terminal B208 3 Yes
Is the inspection result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>Repair or replace harness.
Main Power Window and Door Mirror Switch. Select Switch
Component Function Check
DATA MONITOR
CONSULT
Select “MIR CHNG SW-R” and “MIR CHNG SW-L” in “Data Monitor” mode of “AUTO DRIVE POS.”...
Sliding Sensor
Component Function Check
DATA MONITOR
CONSULT
Select “SLIDE PULSE” in “Data Monitor” mode of “AUTO DRIVE POS.”.
Check that the function operates normally according to the following conditions:
Monitor item Condition Value
SLIDE PULSE
Seat sliding
Operate (forward)
Change (decrease)
Operate (backward)
Change (increase)
Release
No change
Is the inspection result normal?
YES>>
Inspection End...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Work Flow
Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). At the dealer, check whether the customer’s Nissan Murano vehicle has been registered for the telematics service...
Nissan Murano (Z52) 2015-2024 Service Manual: Back Door Lower Finisher
Removal and Installation REMOVALRelease clips from back door lower finisher (1) using a suitable tool. : Clip Remove back door pull handle. Refer to Exploded View. Release remaining back door lower finisher clips using a suitable tool. : Clip Disconnect the harness connector (if equipped) from the back door lower finisher then remove the back door lower finisher...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- Jacking up vehicle and removing the damaged tire
- System malfunction
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
