Nissan Murano: System Description / On Board Diagnostic (obd) System

Nissan Murano (Z52) 2015-2024 Service Manual / Engine / Engine Control System :: Vq35de / System Description / On Board Diagnostic (obd) System

Diagnosis Description

This system is an on board diagnostic system that records exhaust emission-related diagnostic information and detects a sensors/actuator-related malfunction. A malfunction is indicated by the malfunction indicator lamp (MIL) and stored in ECU memory as a DTC. The diagnostic information can be obtained with the diagnostic tool (GST: Generic Scan Tool).

GST (Generic Scan Tool)

When GST is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the Nissan Murano vehicle and then enable various kinds of diagnostic tests. Refer to Diagnosis Description.

NOTE:

Service $0A is not applied for regions where it is not mandated.

Operation. Automatic Speed Control Device (ascd)

Switch Name and Function SWITCHES AND INDICATORS 1. CRUISE indicator 2. SET indicator 3. CANCEL switch 4. ON/OFF (MAIN) switch 5. SET- 6...

Diagnosis System (ecm). Diagnosis Description

1st Trip Detection Logic and Two Trip Detection Logic When a malfunction is detected for the first time, 1st trip DTC and 1st trip Freeze Frame data are stored in the ECM memory...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Parking Brake Rear Cable

Removal and Installation REMOVALRemove center console assembly. Refer to Removal and Installation. Loosen adjusting nut. Refer to Exploded View. NOTE: It is not necessary to remove parking brake front cable. Pull equalizer (A) on parking brake front cable (1) in a rearward direction and then push upward to separate each parking brake rear cable (2) from the parking brake front cable (1)...

Nissan Murano (Z52) 2015-2024 Service Manual: U1507-87 Lost Comm (side Rdr R)

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition U1507-87 LOST COMM(SIDE RDR R) [Lost communication (Side radar right)] Diagnosis condition When engine is running When Blind Spot Warning system is ON Signal (terminal) ITS communication signal Threshold ADAS control unit cannot receive ITS communication signal from side radar RH Diagnosis delay time 2 seconds or more POSSIBLE CAUSE Side radar RH right/left switching signal circuit ITS communication system Side radar RH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Confirmation Procedure DTC CONFIRMATION PROCEDURECHECK DTC PRIORITY If DTC “U1507-87” is displayed with DTC “U1000–01”, first diagnose the DTC “U1000–01”...