Nissan Murano: Symptom Diagnosis / Noise, Vibration and Harshness (nvh) Troubleshooting

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Driveline :: Transfer: Ty21c / Symptom Diagnosis / Noise, Vibration and Harshness (nvh) Troubleshooting

NVH Troubleshooting Chart

Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.

Reference		Inspection			—	Exploded View	Exploded View	Inspection, Inspection	Inspection, Inspection
SUSPECTED PARTS (Possible cause)		TRANSFER OIL (Level low)	TRANSFER OIL (Wrong)	TRANSFER OIL (Level too high)	LIQUID GASKET (Damaged)	O-RING (Worn or damaged)	OIL SEAL (Worn or damaged)	GEAR (Worn or damaged)	BEARING (Worn or damaged)
Symptom	Noise	1	2				3	3	3
Symptom	Transfer oil leakage		3	1	2	2	2

Tire Size Incorrect Is Displayed on Information Display

Diagnosis Procedure While driving, AWD warning icon/display (Tire Size Incorrect: See Owner′s Manual) is displayed on information display.CHECK TIRE Check the following: Tire pressure Wear condition Front and rear tire size (There is no difference between front and rear tires...

Periodic Maintenance. Transfer Oil

Inspection TRANSFER OIL LEAKSCheck that transfer oil is not leaking from transfer assembly or around it.TRANSFER OIL LEVELCAUTION: Do not start engine while checking transfer oil level...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Water Hose

Exploded View 1. Hose clamp 2. CVT water hose A 3. Transaxle assembly 4. CVT water hose B 5. Heater thermostat 6. CVT water hose C 7. Transaxle assembly A. Water outlet Removal and Installation REMOVALWARNING: Do not remove the radiator cap when the engine is hot...

Nissan Murano (Z52) 2015-2024 Service Manual: Combination Switch Reading System

System Description SYSTEM DIAGRAMOUTLINE BCM reads the status of the combination switch (light, turn signal, wiper and washer) and recognizes the status of each switch. BCM has a combination of 5 output terminals (OUTPUT 1 - 5) and 5 input terminals (INPUT 1 - 5) and reads a maximum of 19 switch states...