Nissan Murano: Driver Controls / Mirrors :: System Description

Mirrors :: Preparation. Preparation

Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name   Description  — (J-39570) Chassis Ear Locating the noise  — (J-50397) Squeak and Rattle Kit Repairing the cause of noise  — (J-46534) Trim Tool Set Removing trim components Commercial Service Tools (TechMate No...

Component Parts. Door Mirror System (without Automatic Drive Positioner)

Component Parts Location No. Component Function 1. Auto anti-dazzling inside mirror The sensor built inside the mirror detects the brightness of headlights of the Nissan Murano vehicle behind and automatically changes the light transmission to decrease the brightness...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B2738 Front Sensor Power

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2738–11 FRONT SENSOR POWER (Front sensor power) — Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Front sensor power supply is short to ground Diagnosis delay time 4 seconds or more B2738–12 Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Front sensor power supply is short to voltage Diagnosis delay time 4 seconds or more B2738–87 Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Connection error is detected between sonar control unit and Front sonar sensors Diagnosis delay time 4 seconds or more POSSIBLE CAUSE Harness or connectors Sonar control unit FAIL-SAFEObstacle detection function is deactivated DTC Confirmation Procedure DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Nissan Murano (Z52) 2015-2024 Service Manual: Moonroof

Diagnosis Procedure PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to Special Repair Requirement. Is the inspection result normal? YES>> GO TO 2. NO>> Perform basic inspection. Refer to Work Flow. RETEST THE ANTI-PINCH FUNCTION Check anti-pinch operation...