Nissan Murano: Mirrors / Manual anti-glare rearview mirror (if so equipped)

Nissan Murano (Z52) 2015-2024 Owners Manual / Pre-driving checks and adjustments / Mirrors / Manual anti-glare rearview mirror (if so equipped)

Nissan Murano. Manual anti-glare rearview mirror (if so equipped)

Use the night position Nissan Murano. Manual anti-glare rearview mirror (if so equipped) to reduce glare from the headlights of vehicles behind you at night.

Use the day position Nissan Murano. Manual anti-glare rearview mirror (if so equipped) when driving in daylight hours.

WARNING

Use the night position onlywhennecessary, because it reduces rear view clarity.

 

    Mirrors

    ..

    Automatic anti-glare rearview mirror (if so equipped)

    The inside mirror is designed so that it automatically dims during night time conditions and according to the intensity of the headlights of the vehicle following you...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Power Supply and Ground Circuit (side Radar Lh)


    Work Procedure CHECK FUSES Check that the following fuse is not blown: Signal name Fuse No. Ignition power supply 29(10 A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit. NO>> GO TO 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF...

    Nissan Murano (Z52) 2015-2024 Service Manual: P050a Cold Start Control


    DTC Description DESCRIPTIONECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition.This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions.DTC DETECTION LOGIC ECM does not control engine idle speed properly when engine is started with pre-warming up condition...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com