Nissan Murano: Dtc/circuit Diagnosis / Main Line Between Ipdm-E and Abs Circuit
Diagnosis Procedure
CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
-
Turn the ignition switch OFF.
-
Disconnect the battery cable from the negative terminal.
-
Disconnect the following harness connectors.
-
Check the continuity between the IPDM E/R harness connector and the ABS actuator and electric unit (control unit) harness connector.
| IPDM E/R harness connector |
ABS actuator and electric unit (control unit)
harness connector |
Continuity |
| Connector No. |
Terminal No. |
Connector No. |
Terminal No. |
| E119 |
29 |
E125 |
26 |
Existed |
| 28 |
14 |
Existed |
Is the inspection result normal?
YES>>
Check CAN system type decision again.
YES>>
Error was detected in the main line between the IPDM E/R and the ABS actuator and electric unit (control unit).
NO>>
Repair the main line between the IPDM E/R and the ABS actuator and electric unit (control unit).
Vehicle CAN Communication Circuit
MAIN LINE Malfunction area Reference
Main line between IPDM E/R and ABS actuator and electric unit (control unit)
Diagnosis Procedure
Main line between ABS actuator and electric unit (control unit) and A/C auto amp...
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side)...
Other information:
Exploded View
1.
Fuel filler cap
2.
Grommet
3.
Fuel filler tube
4.
Clip
5.
Fuel tank
6.
Fuel level sensor
7.
O-ring
8.
Lock ring
9.
Sub fuel level assembly
10.
Sub fuel level sensor
11.
Fuel level sensor unit, fuel filter and fuel pump assembly
12...
The battery saver system automatically
turns off the following lights after a period
of time when the ignition switch is placed in
the OFF position and the doors are closed:
Headlights, when the headlight switch
is in the or
position
Interior lights, when left in the ON position
After the headlights automatically turn off
with the headlight switch in the or
position, the headlights will
illuminate
again if the headlight switch is moved
to the OFF position and then turned to
the or
position...