Nissan Murano: Basic Inspection / Led Headlamp Operation Inspection

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Exterior Lighting System :: Led Headlamp / Basic Inspection / Led Headlamp Operation Inspection

Work Procedure

CHECK START

  1. In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp several times. Check that headlamp operates normally each time.

  2. In the cool LED status, turn headlamp ON, wait until headlamp enters the stable status (approximately 5 minutes after turning headlamp ON) and then check that headlamp operates normally without blinking or flickering.

  3. In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning OFF), turn ON and turn OFF the headlamp several times. Check that headlamp operates normally each time.

  4. Turn headlamp ON for approximately 30 minutes and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Refer to Symptom Table.

    Diagnosis and Repair Work Flow

    Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW FOR MALFUNCTION Find out what the customer's concerns are. >> GO TO 2. SYMPTOM CHECK Verify the symptom from the customer's information...

    Dtc/circuit Diagnosis

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Information Display (ascd)


    Component Function Check CHECK INFORMATION DISPLAY Start engine. Press MAIN switch on ASCD steering switch. Drive the Nissan Murano vehicle at more than 40 km/h (25 MPH). CAUTION: Always drive vehicle at a safe speed. Press SET- switch. Check that the reading of the speedometer shows the same value as the set speed indicated in the information display while driving the Nissan Murano vehicle on a flat road...

    Nissan Murano (Z52) 2015-2024 Owners Manual: Automatic operation


    To fully open a window, push the window switch down to the second detent and release it; it need not be held. The window automatically opens all the way. To stop the window, lift the switch up while the window is opening. To fully close a window, pull the switch up to the second detent and release it; it need not be held...

    Categories

    Vehicle security system

    Nissan Murano. Vehicle security system

    Your vehicle has two types of security systems:

    Vehicle security system NISSAN Vehicle Immobilizer System

    The vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.

    read more

     
    Copyright © 2026 www.nimurano.com