Nissan Murano: Driver Controls / Interior Lighting System :: Symptom Diagnosis. Interior Lighting System Symptoms

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Interior Lighting System :: Symptom Diagnosis. Interior Lighting System Symptoms

Symptom Table

NOTE:

Perform the “Self Diagnostic Result” with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

Symptom	Possible cause	Inspection item
All the following lamps do not turn ON: Front room/map lamp assembly Personal lamp 2nd row LH Personal lamp 2nd row RH Luggage room lamp Vanity lamp LH Vanity lamp RH	Harness between BCM and each interior room lamp BCM	Battery saver output/power supply circuit. Refer to Component Function Check.
Interior room lamp does not turn ON even though the door is open (it turns ON when turning the interior room lamp ON). Interior room lamp does not turn OFF even though the door is closed.	Harness between BCM and each door switch Door switch	Door switch circuit. Refer to Component Function Check.
	Harness between BCM and each interior room lamp BCM	Interior room lamp control circuit. Refer to Component Function Check.
Interior room lamp timer does not activate (it turns ON/ OFF when the door opens/closes).	BCM	Replace BCM. Refer to Removal and Installation.
Push-button ignition switch illumination does not illuminate.	Harness between BCM and push-button ignition switch Push-button ignition switch BCM	Push-button ignition switch illumination circuit. Refer to Component Function Check.
Interior room lamp battery saver does not activate.	BCM	Replace BCM. Refer to Removal and Installation.

Push-Button Ignition Switch Illumination Circuit

Component Function Check CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION CONSULT Ignition switch ON. Select “ENGINE SW ILLUMI” in “Active Test” mode of “BCM(INTELLIGENT KEY)”...

Interior Lighting System :: Removal and Installation

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Moonroof Motor Assembly

Description BCM supplies the moonroof motor assembly with power. CPU is integrated in moonroof motor assembly. Tilts up/down & slides open/close by moonroof switch operation. In order to close the moonroof during high speed driving, the Combination meter will send a speed signal to the moonroof CPU to adjust the torque of the motor during the tilt-down operation...

Nissan Murano (Z52) 2015-2024 Service Manual: P014c A/f Sensor 1

DTC Description DTC DETECTION LOGICTo judge malfunctions, this diagnosis measures response time of the A/F signal computed by ECM from the A/F sensor 1 signal. The time is compensated by engine operating (speed and load), fuel feedback control constant, and the A/F sensor 1 temperature index...