Nissan Murano: Driver Controls / Interior Lighting System :: Basic Inspection. Diagnosis and Repair Workflow
OVERALL SEQUENCE
DETAILED FLOW
INTERVIEW FOR MALFUNCTION
Find out what the customer's concerns are.
>>
GO TO 2.
SYMPTOM CHECK
Verify the symptom from the customer's information.
>>
GO TO 3.
BASIC INSPECTION
Check the operation of each part. Check that any concerns occur other than those mentioned in the customer interview.
>>
GO TO 4.
SELF DIAGNOSTIC RESULT
CONSULT
Select “Self Diagnostic Result” mode of “BCM”. Check that any DTC is detected.
Is any DTC detected?
YES>>GO TO 5.
NO>>GO TO 6.
TROUBLE DIAGNOSIS BY DTC
Perform the trouble diagnosis for the detected DTC. Specify the malfunctioning part.
>>
GO TO 9.
FAIL-SAFE ACTIVATION CHECK
Determine if the customer's concern is related to fail-safe activation.
Does the fail-safe activate?
YES>>GO TO 7.
NO>>GO TO 8.
SYSTEM DIAGNOSIS
Perform the system diagnosis for the system in which the fail-safe activates. Specify the malfunctioning part.
>>
GO TO 9.
SYMPTOM DIAGNOSIS
Perform the symptom diagnosis, refer to Symptom Table. Specify the malfunctioning part.
>>
GO TO 9.
MALFUNCTIONING PART REPAIR
Repair or replace the malfunctioning part.
>>
GO TO 10.
REPAIR CHECK (SELF DIAGNOSTIC RESULT)
CONSULT
Select “Self Diagnostic Result” mode of “BCM”. Verify that no DTCs are detected. Erase all DTCs detected prior to the repair. Verify that DTC is not detected again.
Is any DTC detected?
YES>>GO TO 5.
NO>>GO TO 11.
REPAIR CHECK (OPERATION CHECK)
Check the operation of each part.
Does it operate normally?
YES>>Inspection End.
NO>>GO TO 3.
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P01f0 Engine Coolant Temperature
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P01F0 00 Coolant temperature (Coolant temperature relapsed below diagnostic monitoring temperature) Diagnosis condition After engine warmed up Nissan Murano Vehicle speed is more than 60km/h (37 MPH) and no fuel cut Signal (terminal) Engine coolant temperature sensor signal Threshold When the engine coolant temperature is lower than threshold value, after Nissan Murano vehicle is driven at 60km/h (37 MPH) or more for certain period...
Nissan Murano (Z52) 2015-2024 Service Manual: Combination Switch System Symptoms
Symptom Table Perform the data monitor of CONSULT to check for any malfunctioning item. Check the malfunction combinations. Malfunction item: × Malfunction combination Data monitor item FR WIPER HI FR WIPER LOW FR WASHER SW FR WIPER INT INT VOLUME RR WIPER ON RR WIPER INT RR WASHER SW TURN SIGNAL R TURN SIGNAL L TAIL LAMP SW HI BEAM SW HEAD LAMP SW 1 HEAD LAMP SW 2 PASSING SW AUTO LIGHT SW FR FOG SW A × × × × B × × × × C × × × × D × × × × E × × × F × × × G × × × × H × × × I × × × × J × × × × K All Items L If only one item is detected or the item is not applicable to the combinations A to K Identify the malfunctioning part from the agreed combination and repair or replace the part...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- Tire rotation
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
