Nissan Murano: Hood / Hood Hinge

Hood Assembly

Exploded View 1. Hood hinge (RH) 2. Hood 3. Hood stay (RH/LH) 4. Hood stay stud ball (LH/RH) 5. Bumper rubber (LH/RH) 6. Grommet 7...

Hood Stay

Removal and Installation REMOVALSupport hood assembly using a suitable tool. WARNING: Bodily injury may occur if hood assembly is not supported properly when removing hood stay...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0841 Transmission Fluid Pressure Sen/sw a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0841 FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch “A” Circuit Range/Performance) Diagnosis condition When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V DTC other than the applicable DTC is not detected...

Nissan Murano (Z52) 2015-2024 Service Manual: C1b52-17 Blind Spot Warning Indicator Open Circuit

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B52-17 BSW/BSI IND OPEN CIR (Blind Spot Warning indicator open circuit) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Open circuit in Blind Spot Warning indicator circuit is detected Diagnosis delay time – POSSIBLE CAUSE Blind Spot Warning indicator RH circuit Blind Spot Warning indicator RH Side radar RH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Start the engine...