Nissan Murano: Security Control System :: Symptom Diagnosis / Engine Can Not Start

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Security Control System :: Symptom Diagnosis / Engine Can Not Start

Diagnosis Procedure

Engine does not start when ignition switch is pressed.

SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)

Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch)
OK OK No start No start

CONDITIONS OF VEHICLE (OPERATING CONDITIONS)

“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON.

DIAGNOSIS PROCEDURE

Refer to Diagnosis Procedure.

CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE

Check Intelligent Key system symptom table.

Refer to Diagnosis Procedure.

>>

GO TO 2.

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

Select “Self Diagnostic Result” mode of all systems, and check if DTC is detected.

>>

Follow troubleshooting for each DTC.

    Intelligent Key System Symptoms

    Diagnosis Procedure NOTE: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. SYMPTOM TABLE 1 (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) No...

    Engine Does Not Start When Intelligent Key Is Inside of Vehicle

    Diagnosis Procedure Engine does not start when ignition switch is pressed while carrying Intelligent Key.NOTE: Before starting diagnosis check that Nissan Murano vehicle condition is as shown in “Conditions of vehicle”, and check each symptom...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis and Repair Work Flow


    Work Flow NOTE: The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTCs Register TPMS sensor IDs COLLECT INFORMATION FROM CUSTOMER Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred)...

    Nissan Murano (Z52) 2015-2024 Owners Manual: Maximum Gross Vehicle Weight (GVW)/maximum Gross Axle Weight (GAW)


    The GVW of the towing vehicle must not exceed the Gross Vehicle Weight Rating (GVWR) shown on the F.M.V.S.S./C.M.V.S.S. certification label. The GVW equals the combined weight of the unloaded vehicle, passengers, luggage, hitch, trailer tongue load and any other optional equipment...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com