Nissan Murano: Road Wheels & Tires :: Symptom Diagnosis / Id Registration Cannot Be Completed

Nissan Murano (Z52) 2015-2024 Service Manual / Suspension / Road Wheels & Tires :: Symptom Diagnosis / Id Registration Cannot Be Completed

Diagnosis Procedure

NOTE:

The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs

Display tire pressure reported by the TPMS sensor

Read TPMS DTCs

Register TPMS sensor IDs

CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL

Check tire pressure sensor activation tool.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sensor activation tool.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Work Procedure.

CAUTION:

To perform ID registration, observe the following points:

Never register ID in a place where radio waves are interfered (e.g. radio tower).

Never register ID in a place close to Nissan Murano vehicles including TPMS.

Is tire pressure sensor ID registration completed?

YES>>

Inspection End.

NO>>

GO TO 3.

CHECK TIRE PRESSURE SIGNAL

Change the work location and perform ID registration again.

NOTE:

Depending on the tire pressure sensor position*, a blind spot exists, and the tire pressure receiver gets poor reception. If an ID registration is performed under this condition, the registration may not be completed. In such case, follow the instructions below to improve the radio wave receiving environment.

Rotate tire by 90°, 180°, or 270°. (This Step is to change tire pressure sensor position.)

Open the door close to the tire of which ID registration is ongoing.

*: Radio wave reception condition depends on Nissan Murano vehicle architecture (e.g. body harness layout, tire wheel design) or environment.

When ID registration is performed, which wheels do not react?

All wheels react and ID registration is possible.>>

Inspection End.

Only certain wheel(s) do not react.>>

Replace applicable tire pressure sensor. Refer to Removal and Installation.

All wheels do not react.>>

Check the tire pressure receiver (remote keyless entry receiver). Refer to Diagnosis Procedure.

Easy Fill Tire Alert Does Not Activate

Diagnosis Procedure The Easy Fill tire alert does not function while inflating a tire when the select lever position is in P-range with the ignition switch is placed ON...

Noise, Vibration and Harshness (nvh) Troubleshooting

NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. Reference page Balancing Wheels Balancing Wheels Balancing Wheels Tire Air Pressure Balancing Wheels — — Tire Air Pressure NVH Troubleshooting Chart Symptom Table NVH Troubleshooting Chart or NVH Troubleshooting Chart NVH Troubleshooting Chart or NVH Troubleshooting Chart — — NVH Troubleshooting Chart or NVH Troubleshooting Chart ...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Sonar System :: Ecu Diagnosis Information. Sonar Control Unit

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor Item Condition Value/Status Nissan Murano Vehicle SPEED While driving, equivalent to speedometer reading mph, km/h SONAR C/U POWER SUPPLY Key ON...

Nissan Murano (Z52) 2015-2024 Owners Manual: Conditions the Remote Engine Start will notwork

The Remote Engine Start will not operate if any of the following conditions are present: The ignition switch is placed in the ON position. The hood is not securely closed. The hazard indicator lights are on. The engine is still running. The engine must be completely stopped...