Nissan Murano: Power Control System :: Ipdm E/r / Dtc/circuit Diagnosis

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Power Control System :: Ipdm E/r / Dtc/circuit Diagnosis

Ecu Diagnosis Information. Ipdm E/r

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items: Monitor Item Condition Value/Status MOTOR FAN REQ Engine idle speed Changes depending on engine coolant temperature, air conditioner operation status, Nissan Murano vehicle speed, etc...

U1000 Can Comm Circuit

DTC Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Air Conditioner


CONSULT Function (BCM - AIR CONDITIONER) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description FAN ON SIG [On/Off] Indicates condition of fan switch. AIR COND SW [On/Off] Indicates condition of A/C switch...

Nissan Murano (Z52) 2015-2024 Service Manual: U1232 Steering Angle Sensor


DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1232 ST ANGLE SEN CALIB (Steering angle sensor calibration) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold — Diagnosis delay time — POSSIBLE CAUSE Neutral position adjustment of the steering angle sensor is incomplete Steering angle sensor FAIL-SAFEPredictive course line is not displayed DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com