Nissan Murano: Removal and Installation / Drive Pinion Oil Seal
 |
Rear final drive assembly |  |
Drive pinion oil seal |  |
Electric controlled coupling assembly |
 |
Oil seal lip | ||||
 : Always replace after every disassembly. |
|||||
 : Apply gear oil. |
|||||
 : Apply multi-purpose grease. |
|||||
REMOVAL
Drain gear oil. Refer to Draining.
Remove electric controlled coupling assembly. Refer to Removal and Installation.
Remove drive pinion oil seal using oil seal remover (commercial service tool).
INSTALLATION
Install drive pinion oil seal (1) using Tool (A).
| Oil seal installation length (D) | : 0.8 – 1.2 mm (0.031 – 0.047 in) |
| Tool number | : ST35271000 ( — ) |
CAUTION:
-
Do not reuse oil seal.
-
When installing, do not incline oil seal.
-
Apply multi-purpose grease onto oil seal lips, and gear oil onto the circumference of oil seal.
Install electric controlled coupling assembly. Refer to Removal and Installation.
Refill gear oil to the final drive. Refer to Refilling.
Perform inspection after installation. Refer to Inspection.
INSPECTION
INSPECTION AFTER INSTALLATION
Check surface for cracks, leaks, or damage.
Replace any defective parts.
Check oil level and final drive for oil leakage. Refer to Inspection.
Side Oil Seal
Exploded View
Rear final drive assembly
Side oil seal
Oil seal lip
: Always replace after every disassembly...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Low Tire Pressure Warning Lamp Stays on
Diagnosis Procedure CHECK BCM CONNECTORS Ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace damaged connectors. BCM POWER SUPPLY AND GROUND CIRCUITS Check BCM power supply and ground circuits...
Nissan Murano (Z52) 2015-2024 Service Manual: Body Control System
System Description OUTLINE BCM controls various electrical components. It receives the information required from CAN communication and the signals received from each switch and sensor. BCM has a combination switch reading function for reading the status of combination switches (light, turn signal, wiper and washer) in addition to functions for controlling the operation of various electrical components...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Power Steering Fluid (PSF)
- GAS STATION INFORMATION
- Checking engine oil level
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
