Nissan Murano: System Description / Diagnosis System (side Radar Lh)
DESCRIPTION
CONSULT performs the following functions by communicating with the side radar LH.
| Select diag mode | Function |
|---|---|
| Self Diagnostic Result | Displays memorized DTC in the side radar. |
| Data Monitor | Displays real-time data of side radar. |
| Active Test | Enables operation check of electrical loads by sending driving signal to them. |
| ECU Identification | Displays part number of side radar. |
SELF DIAGNOSTIC RESULT
Self Diagnostic Result
Displays memorized DTC in side radar LH. Refer to DTC Index.
FFD (Freeze Frame Data)
The side radar records the following data when the malfunction is detected.
| Freeze Frame Data item | Description |
|---|---|
| VHCL SP from ADAS | The Nissan Murano vehicle speed (from ADAS control unit) at the moment a malfunction is detected is displayed |
| TURN SIG STATUS | Turn signal status at the moment a malfunction is detected is displayed |
DATA MONITOR
|
Monitored item [Unit] | Description |
|---|---|
|
BSW/CTA WARN STATUS [On/Off] |
Indicates [ON/OFF] status of Nissan Murano vehicle detection |
|
CTA SYSTEM ON [On/Off] |
Indicates [ON/OFF] status of Rear Cross Traffic Alert system |
|
BSW STATUS [On/Off] |
Indicates [ON/OFF] status of Blind Spot Warning system |
|
VHCL SPD SE [km/h] |
Indicates Nissan Murano vehicle speed [km/h] |
|
TURN SIGNAL [LH/RH/Off] |
Indicates the [LH/RH/OFF] operation of the signal |
|
SHIFT POSITION [P/R/N/D] |
Indicates position of transmission range switch |
|
LUMINANCE (LEFT) [Hi/Lo] |
Indicates the left side luminance level of the radar |
|
LUMINANCE (RIGHT) [Hi/Lo] |
Indicates the right side luminance level of the radar |
ACTIVE TEST
CAUTION:
-
Never perform the “Active Test” while driving.
-
“Active Test” cannot be started while the Blind Spot Warning indicator is illuminated.
| Active test item | Operation | Description |
|---|---|---|
| BSW/BSI INDICATOR DRIVE | On | Outputs the voltage to illuminate the Blind Spot Warning indicator. |
| Off | Stops the voltage to illuminate the Blind Spot Warning indicator. |
Handling Precaution
Precautions for Predictive Forward Collision Warning
The Intelligent Forward Collision Warning system is designed to warn the driver before a collision, but will not avoid a collision...
Diagnosis System (lane Camera Unit)
CONSULT Function (LANE CAMERA UNIT)
APPLICATION ITEMSCONSULT performs the following functions by communicating with the lane camera unit. Diagnosis mode Description
Work support
Performs the camera aiming...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: B1305 Control Unit Internal Fault
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1305–04 Control unit internal error (AV control unit internal fault) [—] Diagnosis condition When ignition switch is ON...
Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Heated Steering Wheel System
Component Parts Location A. Left of the steering column No. Component Function 1. Heated steering wheel Refer to Heated Steering Wheel. 2. A/C auto amp. Refer to A/C Auto Amp.. 3. Heated steering wheel relay Refer to Heated Steering Wheel Relay...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Fuel recommendation
- Jacking up vehicle and removing the damaged tire
- Warning lights
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
