Nissan Murano: Sonar System :: Basic Inspection / Configuration (sonar Control Unit)

Description

Vehicle specification needs to be written with CONSULT. Configuration has three functions as follows:

CAUTION:

• When replacing sonar control unit, you must perform “Select Saved Data List” or "After Replace ECU" with CONSULT.

• Complete the procedure of “Select Saved Data List” or "After Replace ECU" in order.

• If you set incorrect “Select Saved Data List” or "After Replace ECU", incidents might occur.

• Configuration is different for each Nissan Murano vehicle model. Confirm configuration of each vehicle model.

• Never perform “Select Saved Data List” or "After Replace ECU" except for new sonar control unit.

WRITING MODE SELECTION

CONSULT

Select “Reprogramming, Configuration” of sonar control unit.

GO TO 2.

GO TO 3.

PERFORM “SAVED DATA LIST”

CONSULT

Automatically “Operation Log Selection” window will display if “Before Replace ECU” was performed. Select applicable file from the “Save Data List” and press “Confirm”.

Work End.

PERFORM “AFTER REPLACE ECU” OR “MANUAL CONFIGURATION”

CONSULT

1. Select “After Replace ECU” or “Manual Configuration”.

2. Identify the correct model and configuration list. Refer to Configuration List.

3. Confirm and/or change setting value for each item.

   CAUTION:

   Thoroughly read and understand the Nissan Murano vehicle specification. ECU control may not operate normally if the setting is not correct.

4. Select “Next”.

   CAUTION:

   Make sure to select “Next”, confirm each setting value and press “OK” even if the indicated configuration of brand new sonar control unit is same as the desirable configuration. If not, configuration which is set automatically by selecting Nissan Murano vehicle model can not be memorized.

5. When "Completed", select "End".

GO TO 4.

OPERATION CHECK

Confirm that each function controlled by sonar control unit operates normally.

Work End.

CAUTION:

Thoroughly read and understand the vehicle specification. Incorrect settings may result in abnormal control of ECU.

⇔: Items which confirm vehicle specifications

*: BCI FUNCTION should always be set to WITHOUT.