Nissan Murano: Basic Inspection / Configuration (adas Control Unit)

Description

• Since vehicle specifications are not included in the ADAS control unit after replacement, it is required to write Nissan Murano vehicle specifications using CONSULT.

• Configuration has three functions as follows:

  Function		Description
  Read/Write Configuration	Before ECU	Allows the reading of Nissan Murano vehicle specification written in ADAS control unit to store the specification in CONSULT.
  	After ECU replacement	Allows the writing of the Nissan Murano vehicle information stored in CONSULT into the ADAS control unit.
  Manual Configuration		Allows the writing of the Nissan Murano vehicle specification into the ADAS control unit by hand.

CAUTION:

• Use “Manual Configuration” only when “TYPE ID” of ADAS control unit cannot be read.

• If an error occurs during configuration, start over from the beginning.

CHECKING PARTS NUMBER

CONSULT

1. Select “Before Replace ECU” of “Read/Write Configuration”.

2. Check that “Parts number” is displayed on CONSULT.

Is “Parts number” displayed?

GO TO 2.

GO TO 6.

VERIFYING PARTS NUMBER (1)

CONSULT

Compare “Parts number” displayed on the CONSULT screen with the one searched for using EPC (service parts catalog) to check that these “Parts number” agree with each other.

NOTE:

For the “Parts number” searched for using EPC (service parts catalog), use the last five digits of the “Parts number”.

GO TO 3.

SAVING PARTS NUMBER

CONSULT

Save “Parts number” on CONSULT.

GO TO 4.

REPLACE ADAS CONTROL UNIT (1)

Replace ADAS control unit. Refer to Removal and Installation.

GO TO 5.

WRITING (AUTOMATIC WRITING)

CONSULT

1. Select “After Replace ECU” of “Re/programming, Configuration” or that of “Read / Write Configuration”.

2. Select the “Parts number” agreeing with the one stored on CONSULT and the one searched for using EPC (service parts catalog) to write the “Parts number” into the ADAS control unit.

GO TO 8.

REPLACE ADAS CONTROL UNIT (2)

Replace ADAS control unit. Refer to Removal and Installation.

GO TO 7.

WRITING (MANUAL WRITING)

CONSULT

1. Select “Manual Configuration”.

2. Select the “Parts number” searched for using EPC (service parts catalog) to write the “Parts number” into the ADAS control unit.

   NOTE:

   For the “Parts number” searched for using EPC (service parts catalog), use the last five digits of the “Parts number”.

GO TO 8.

VERIFYING PARTS NUMBER (2)

CONSULT

Compare a “Parts number” displayed on the CONSULT screen with the one searched by using EPC (service parts catalog) to check that these “Parts number” agree with each other.

NOTE:

For the “Parts number” searched for using EPC (service parts catalog), use the last five digits of the “Parts number”.

GO TO 9.

OPERATION CHECK

Confirm that each function controlled by ADAS control unit operates normally.

Work End.