Nissan Murano: Engine cooling system / Changing engine coolant

Nissan Murano (Z52) 2015-2024 Owners Manual / Do-it-yourself / Engine cooling system / Changing engine coolant

A NISSAN dealer can change the engine coolant. The service procedure can be found in the NISSAN Service Manual.

Improper servicing can result in reduced heater performance and engine overheating.

WARNING

To avoid the danger of being scalded, never change the coolant when the engine is hot.
Never remove the radiator or engine coolant reservoir cap when the engine is hot. Serious burns could be caused by high pressure fluid escaping from the radiator.
Avoid direct skin contact with used coolant. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
Keep coolant out of the reach of children and pets.

Engine coolant must be disposed of properly. Check your local regulations.

Checking engine coolant level

Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level , add coolant to the MAX level . If the reservoir is empty, check the coolant level in the radiator when the engine is cold...

Engine oil

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Bose Speaker Amp

Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal (Wire color) Description Condition Reference value (Approx.) + – Signal name Input/Output 1 (W) 2 (V/G) Instrument panel tweeter LH Output Ignition switch ON Sound output 4 (W) 3 (G) Instrument panel tweeter RH Output Ignition switch ON Sound output 5 (W) 6 (B) Sound signal subwoofer Output Ignition switch ON Sound output 7 (GR) — Ground — Ignition switch ON 0 V 10 (SB) 7 (GR) Battery power supply Input Ignition switch OFF Battery voltage 11 (G) 7 (GR) Battery power supply Input Ignition switch OFF Battery voltage 12 (B) — Ground — Ignition switch ON 0 V 13 (W) 8 (B) Sound signal subwoofer Output Ignition switch ON Sound output 14 (R) 9 (P) Sound signal rear door speaker RH Output Ignition switch ON Sound output 18 (V/R) 19 (O) Sound signal front door speaker and tweeter LH Output Ignition switch ON Sound output 20 (W) Ground Amp...

Nissan Murano (Z52) 2015-2024 Service Manual: A/c Auto Amp.

Values on the Diagnosis Tool NOTE: The following table includes information (items) inapplicable to this Nissan Murano vehicle: For information (items) applicable to this vehicle, refer to CONSULT display items. Monitor item Condition Value/Status AMB TEMP SEN Ignition switch ON — Equivalent to ambient temperature IN-VEH TEMP Ignition switch ON — Equivalent to in-Nissan Murano vehicle temperature (front side) INT TEMP SEN Ignition switch ON — Equivalent to front evaporator fin temperature SUNLOAD SEN Ignition switch ON — Equivalent to sunload (driver side) AMB SEN CAL Ignition switch ON — Equivalent to ambient temperature IN-VEH CAL Ignition switch ON — Equivalent to in-Nissan Murano vehicle temperature (front side) INT TEMP CAL Ignition switch ON — Equivalent to front evaporator fin temperature SUNL SEN CAL Ignition switch ON — Equivalent to sunload (driver side) COMP REQ SIG Engine: Run at idle after warming up A/C switch: ON (Compressor operation status ON) On A/C switch: OFF (Compressor operation status OFF) Off FAN REQ SIG Engine: Run at idle after warming up Front blower motor: ON On Front blower motor: OFF Off FAN DUTY Engine: Run at idle after warming up Front blower motor: ON 25 – 81 Front blower motor: OFF 0 XM Ignition switch ON — Value according to target air flow temperature (driver side) PA TARGET A/TEMP Ignition switch ON — Value according to target air flow temperature (passenger side) ENG COOL TEMP Ignition switch ON — Equivalent to engine coolant temperature Nissan Murano Vehicle SPEED Driving — Equivalent to speedometer reading PASS SUNL CAL Ignition switch ON — Equivalent to sunload (passenger side) PASS SUNL SEN CAL Ignition switch ON — Equivalent to sunload (passenger side) Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal No...