Nissan Murano: Engine cooling system / Checking engine coolant level
Check the coolant level in the reservoir
when the engine is cold. If the coolant
level is below the MIN level 
, add
coolant
to the MAX level 
. If the reservoir
is empty,
check the coolant level in the radiator
when the engine is cold. If there is insufficient
coolant in the radiator, fill the radiator
with coolant up to the filler opening and
also add it to the reservoir up to the MAX
level 
.
This vehicle contains Genuine NISSAN Long Life Antifreeze/Coolant (blue). The life expectancy of the factory-fill coolant is 105,000 miles (168,000 km) or 7 years. Mixing any other type of coolant or the use of non-distilled water will reduce the life expectancy of the factory-fill coolant. For additional information, refer to the "Maintenance and schedules" section of this manual.
If the cooling system frequently requires coolant, have it checked. It is recommended that you visit a NISSAN dealer for this service.
For additional information on the location of the engine coolant reservoir, refer to “Engine compartment check locations” in this section.
Engine cooling system
The engine cooling system is filled at the
factory with a pre-diluted mixture of 50%
Genuine NISSAN Long Life
Antifreeze/Coolant (blue) and 50% water to
provide year-round antifreeze and coolant
protection...
Changing engine coolant
A NISSAN dealer can change the engine
coolant. The service procedure can be
found in the NISSAN Service Manual.
Improper servicing can result in reduced
heater performance and engine overheating...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Variable Induction Air System
Component Function Check CHECK OVERALL FUNCTION-I With CONSULT Start engine and warm it up to the normal operating temperature. Perform “VIAS S/V-1” in “ACTIVE TEST” mode with CONSULT. Turn VIAS control solenoid valve 1 “ON” and “OFF”, and check that power valve actuator 1 rod moves...
Nissan Murano (Z52) 2015-2024 Service Manual: P0524 Engine Oil Pressure
DTC Description DTC DETECTION LOGICAn EOP sensor signal voltage applied to ECM remains lower than the specified value continuously for 10 seconds or more when the engine speed is 1,000 rpm or more. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0524 ENGINE OIL PRESSURE (Engine oil pressure too low) Diagnosis condition — Signal (terminal) Voltage signal transmitted from EOP sensor signal to ECM Threshold An EOP sensor signal voltage applied to ECM remains lower than the specified value continuously when the engine speed is 1,000 rpm or more Diagnosis delay time 10 seconds or more POSSIBLE CAUSE Decrease in engine oil pressure Decrease in engine oil level Engine oil condition EOP sensor Cause of engine oil consumption FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Engine oil pressure ECM illuminates oil pressure warning lamp on the combination meter...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Jacking up vehicle and removing the damaged tire
- All-Wheel Drive (AWD) (if so equipped)
- Shift lock release
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.