Nissan Murano: System / Can Communication System
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a Nissan Murano vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.
System
..
Diag on Can
System Description
SYSTEM DIAGRAM Name Harness Description
DDL1
Tx
Rx
For communications with the diagnostic tool. (CAN-H and CAN-L are used for controlling)
DDL2
K-LINE
For communications with the diagnostic tool...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Left Knee Air Bag Module
Exploded View 1. Left knee air bag module A. Refer to Removal and Installation. Front Removal and Installation WARNING: Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes...
Nissan Murano (Z52) 2015-2024 Service Manual: Moonroof
Diagnosis Procedure PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to Special Repair Requirement. Is the inspection result normal? YES>> GO TO 2. NO>> Perform basic inspection. Refer to Work Flow. RETEST THE ANTI-PINCH FUNCTION Check anti-pinch operation...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Fuel recommendation
- How to enable/disable the LDW system
- GAS STATION INFORMATION
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.