Nissan Murano: Security Control System :: Dtc/circuit Diagnosis / B210b Str Cont Rly on Circ

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Security Control System :: Dtc/circuit Diagnosis / B210b Str Cont Rly on Circ

DTC Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N (Neutral) or P (Park) position. It is installed in parallel with the starter relay.

DTC DETECTION LOGIC

NOTE:

  • If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Description.

  • If DTC B210B is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC Description.

DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
B210B

START CONT RLY ON CIRC

(Starter control relay on circuit)
Diagnosis condition When ignition switch ON.
Signal (terminal)
Threshold

IPDM E/R detects that the relay is stuck at ON position even if the following conditions are met for about 1 second:

  • Starter control relay ON/OFF signal from BCM

  • Transmission range switch input signal

Diagnosis delay time

POSSIBLE CAUSE

  • IPDM E/R

  • Harness or connector

FAIL-SAFE

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Place power supply position to start under the following conditions and wait for at least 1 second:

    • CVT selector lever is in the P (Park) or N (Neutral) position.

    • Depress the brake pedal.

  2. Select “Self Diagnostic Result” mode of “IPDM E/R”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO>>

Inspection End.

Diagnosis Procedure

INSPECTION START

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “IPDM E/R”.

  3. Touch “ERASE”.

  4. Perform DTC Confirmation Procedure. Refer to DTC Confirmation Procedure.

Is DTC detected?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Inspection End.

    P1614 Chain of Immu-Key

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition P1614 CHAIN OF IMMU-KEY (Chain of immobilizer-key) Diagnosis condition When ignition switch ON...

    B210d Starter Rly on Circ

    DTC Description Located in IPDM E/R, the starter relay runs the starter motor. The starter relay is turned ON by the BCM when ignition switch is in START position...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Magnet Clutch


    Component Function Check CHECK MAGNET CLUTCH OPERATION Perform auto active test of IPDM E/R. Refer to Diagnosis Description. Does it operate normally? YES>> Inspection End. NO>> Refer to Diagnosis Procedure. Diagnosis Procedure CHECK FUSE Ignition switch OFF...

    Nissan Murano (Z52) 2015-2024 Service Manual: Warning Chime System Symptoms


    Symptom Table CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Possible cause Inspection item The light reminder warning does not sound. Harness between BCM and front door switch LH...

    Categories

    Front manual seat adjustment (if so equipped)

    Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.

    Forward and backward

    Nissan Murano. Front manual seat adjustment (if so equipped)

    read more

     
    Copyright © 2026 www.nimurano.com