Nissan Murano: Precautions when starting and driving / Avoiding collision and rollover
WARNING
Failure to operate this vehicle in a safe
and prudent manner may result in loss
of control or an accident.
Be alert and drive defensively at all times.
Obey all traffic regulations. Avoid excessive
speed, high speed cornering, or sudden
steering maneuvers,because these driving
practices could cause you to lose control of
your vehicle.
As with any vehicle, loss of control could
result in a collision with other vehicles or
objects or cause the vehicle to roll over,
particularly if the loss of control causes
the vehicle to slide sideways.
Be attentive at all times, and avoid driving
when tired. Never drive when under the influence
of alcohol or drugs (including prescription
or over-the-counter drugs which
may cause drowsiness). Always wear your
seat belt as outlined in the “Safety – Seats,
seat belts and supplemental restraint system”
section of this manual, and also instruct
your passengers to do so.
Seat belts help reduce the risk of injury in
collisions and rollovers. In a rollover crash,
an unbelted or improperly belted person
is significantly more likely to be injured
or killed than a person properly wearing
a seat belt.
Utility vehicles have a significantly
higher rollover rate than other types of
vehicles.
They have higher ground clearance than
passenger cars to make them capable of
performing in a variety of on-pavement
and off-road applications...
While driving, the right side or left side
wheels may unintentionally leave the road
surface. If this occurs, maintain control of
the vehicle by following the procedure below...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detecting condition
B2416–1B
TOUCH SEN R OPEN
(Touch sensor right open)
Diagnosis condition
All times
Signal (terminal)
Touch sensor RH signal (automatic back door control module connector terminal: 4)
Threshold
When one of the following conditions is satisfied
Touch sensor RH circuit is open
Disconnect touch sensor RH connector
Diagnosis delay time
–
B2416–1E
TOUCH SEN R OPEN
(Touch sensor right open)
Diagnosis condition
All times
Signal (terminal)
Touch sensor RH signal (automatic back door control module connector terminal: 4)
Threshold
When one of the following conditions is satisfied
Touch sensor RH circuit is open
Disconnect touch sensor RH connector
Diagnosis delay time
–
POSSIBLE CAUSE
Improper installation of touch sensor
Touch sensor RH
Harness or connectors (touch sensor circuit is open)
Automatic back door control module
FAIL-SAFEInhibit automatic back door system auto open/close function
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more