Nissan Murano: Vehicle-to-vehicle distance control mode switches / Automatic cancellation

Nissan Murano (Z52) 2015-2024 Owners Manual / Starting and driving / Intelligent Cruise Control (ICC) (if so equipped) / Vehicle-to-vehicle distance control mode switches / Automatic cancellation

A chime sounds under the following conditions and the control is automatically canceled:

When the vehicle ahead is not detected and your vehicle is traveling below the speed of 15 mph (24 km/h)
When the system judges the vehicle is at a standstill
Whenthe shift lever is not in theD(Drive) position, Manual mode.
When the parking brake system is applied
When the VDC system is turned off
When VDC operates
When distance measurement becomes impaired due to adhesion of dirt or obstruction to the sensor
When a wheel slips
When the radar signal is temporarily interrupted

Approach warning

If your vehicle comes closer to the vehicle ahead due to rapid deceleration of that vehicle or if another vehicle cuts in, the system warns the driver with the chime and ICC system display...

Vehicle-to-vehicle distance control mode limitations

WARNING Listed below are the system limitations for the ICC system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U0104-82 Adas Can 1

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0104-82 ADAS CAN CIR1 (ADAS control unit CAN circuit 1) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Side radar detected an error of ITS communication signal that was received from ADAS control unit Diagnosis delay time – POSSIBLE CAUSE ADAS control unit Side radar LH FAIL-SAFEThe following systems are canceled: Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) DTC Confirmation Procedure CHECK DTC PRIORITY If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”...

Nissan Murano (Z52) 2015-2024 Service Manual: Vehicle Security System

System Description SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNAL CHART Component Signal description IPDM E/R Mainly receives the following signal from BCM via CAN communication. Push-button ignition switch signal Door lock and unlock switch signal Each door request switch signal Transmit the following signal to BCM via CAN communication...