Nissan Murano: Basic Inspection / Additional Service When Replacing Distance Sensor (icc Sensor)

Nissan Murano (Z52) 2015-2024 Service Manual / Cruise Control & Driver Assistance / Cruise Control System :: Icc / Basic Inspection / Additional Service When Replacing Distance Sensor (icc Sensor)

Description

Always perform the radar alignment aiming adjustment after removing and installing or replacing the distance sensor (ICC sensor).

CAUTION:
The system does not operate normally unless the distance sensor (ICC sensor) is aligned properly.
Perform the ICC system action test to check that the ICC system operates normally.

Work Procedure

DISTANCE SENSOR (ICC SENSOR) ALIGNMENT ADJUSTMENT

Adjust the distance sensor (ICC sensor) alignment. Refer to Work Procedure.

GO TO 2.

ICC SYSTEM ACTION TEST

Perform the ICC system action test. Refer to Description.
Check that the ICC system operates normally.

Inspection End.

Diagnosis and Repair Work Flow

Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW FOR MALFUNCTION It is important to clarify the customer’s concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully...

Distance Sensor (icc Sensor) Alignment

Work Procedure Always perform the radar alignment after removing and installing or replacing the distance sensor.Application Notice Type Description TYPE 1 When using KV99112700 for radar alignment...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: Brake precautions

Vacuum assisted brakes The brake booster aids braking by using engine vacuum. If the engine stops, you can stop the vehicle by depressing the brake pedal. However, greater foot pressure on the brake pedal will be required to stop the vehicle and stopping distance will be longer...

Nissan Murano (Z52) 2015-2024 Service Manual: B2738 Front Sensor Power

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2738–11 FRONT SENSOR POWER (Front sensor power) — Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Front sensor power supply is short to ground Diagnosis delay time 4 seconds or more B2738–12 Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Front sensor power supply is short to voltage Diagnosis delay time 4 seconds or more B2738–87 Diagnosis condition Ignition switch ON Signal (terminal) Front sensor power supply (terminal 11) Threshold Connection error is detected between sonar control unit and Front sonar sensors Diagnosis delay time 4 seconds or more POSSIBLE CAUSE Harness or connectors Sonar control unit FAIL-SAFEObstacle detection function is deactivated DTC Confirmation Procedure DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...