Nissan Murano: Basic Inspection / Additional Service When Replacing Awd Control Unit

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Driveline :: Transfer: Ty21c / Basic Inspection / Additional Service When Replacing Awd Control Unit

Description

When replacing AWD control unit, unit characteristics writing is required.

Work Procedure

PERFORM WRITING UNIT CHARACTERISTICS

Perform writing unit characteristics of electric controlled coupling.

>>

Refer to Work Procedure.

    Diagnosis and Repair Work Flow

    Work Flow DETAILED FLOWINTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing Diagnostic Work Sheet and reproduce symptoms as well as fully understand it...

    Unit Characteristics Writing

    Description When replacing AWD control unit, rear final drive assembly and/or electric controlled coupling, unit characteristics of electric controlled coupling writing is required...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance


    The two radar sensors for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such as ice, frost or dirt obstructing the radar sensors...

    Nissan Murano (Z52) 2015-2024 Owners Manual: System operation


    The automatic drive positioner system will not work or will stop operating under the following conditions: When the vehicle speed is above 4 mph (7 km/h). When any of the memory switches are pushed while the automatic drive positioner is operating...

    Categories

    Luggage hooks

    Nissan Murano. Luggage hooks

    When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

    The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

    read more

     
    Copyright © 2025 www.nimurano.com