Nissan Murano: Basic Inspection / Action Test

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake Control System :: Automatic Emergency Braking / Basic Inspection / Action Test

Description

  • Perform action test to verify the customer's concern.

  • Perform action test and check the system operation after system diagnosis.

Inspection Procedure

CHECK AEB SYSTEM SETTING

  1. Start the engine.

  2. Check that the AEB system setting can be enabled/disabled on the Nissan Murano vehicle information display.

  3. Turn OFF the ignition switch and wait for 30 seconds or more.

  4. Check that the previous setting is saved when the engine starts again.

>>

GO TO 2.

CHECK AEB SYSTEM

  1. Enable the setting of the AEB system on the Nissan Murano vehicle information display.

  2. Check AEB warning lamp is OFF.

>>

Inspection End.

    Diagnosis and Repair Work Flow

    Work Flow OVERALL SEQUENCEDETAILED FLOWINTERVIEW FOR MALFUNCTION It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully...

    Dtc/circuit Diagnosis. Automatic Emergency Braking

    Diagnosis Procedure AUTOMATIC EMERGENCY BRAKE DIAGNOSIS The system will be cancelled automatically with a beep sound and AEB warning lamp on the combination meter will illuminate, when the system will not operate properly...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Door Lock and Unlock Switch. Driver Side


    Component Function Check CHECK FUNCTION CONSULT Select “CDL LOCK SW” or “CDL UNLOCK SW” in “Data Monitor” mode of “BCM(DOOR LOCK)”. Check that the function operates normally according to the following conditions: Monitor Item Condition Status CDL LOCK SW Door lock and unlock switch Lock ON Unlock OFF CDL UNLOCK SW Lock OFF Unlock ON Is the inspection result normal? YES>> Door lock and unlock switch is OK...

    Nissan Murano (Z52) 2015-2024 Service Manual: Moonroof Switch


    Removal and Installation REMOVALRemove map lamp assembly. Refer to Removal and Installation. Remove center pillar upper finisher. Refer to Removal and Installation. Remove sun visor (LH). Refer to Exploded View. Partially lower front of headlining. Refer to Exploded View...

    Categories

    Fuel gauge

    Nissan Murano. Fuel gauge

    The gauge indicates the approximate fuel level in the tank.

    The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

    The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

    read more

     
    Copyright © 2026 www.nimurano.com