Nissan Murano: Wiper & Washer :: Dtc/circuit Diagnosis / Wiper and Washer Fuse
CHECK FUSES
Check that the following fuses are not blown:
| Component | Location | Fuse No. | Capacity |
|---|---|---|---|
| Front wiper motor | IPDM E/R | 48 | 30 A |
| Front and rear washer motor | IPDM E/R | 47 | 10 A |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>Inspection End.
Front Wiper Motor Lo Circuit
Component Function Check
CHECK FRONT WIPER LO OPERATION
CONSULT
Select “FRONT WIPER” in “Active Test” mode of “IPDM E/R”.
While operating the test item, check front wiper operation...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance
The two radar sensors for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such as ice, frost or dirt obstructing the radar sensors...
Nissan Murano (Z52) 2015-2024 Service Manual: Fuel Tank. Fwd
Exploded View 1. Fuel filler cap 2. Grommet 3. Fuel filler tube 4. Clip 5. Fuel tank 6. Fuel level sensor 7. O-ring 8. Lock ring 9. Sub fuel level assembly 10. Sub fuel level sensor 11. Fuel level sensor unit, fuel filter and fuel pump assembly 12...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Checking engine oil level
- Rear bench seat adjustment
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
