Nissan Murano: Rear Rh Side Power Window Alone Does Not Operate / When Rear Power Window Switch Rh Is Operated
Diagnosis Procedure
REPLACE REAR POWER WINDOW SWITCH RH
Replace rear power window switch RH.
Refer to Removal and Installation.
>>
Inspection End.
Diagnosis Procedure
CHECK REAR POWER WINDOW SWITCH RH SERIAL LINK CIRCUIT
Check rear power window switch RH serial link circuit.
Refer to Diagnosis Procedure...
Diagnosis Procedure
CHECK REAR POWER WINDOW SWITCH POWER SUPPLY AND GROUND CIRCUIT
Check rear power window switch power supply and ground circuit.
Refer to Diagnosis Procedure...
Other information:
Description
Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*.*: New one means an ECM that has never been energized on-board.(In this step, initialization procedure by CONSULT is not necessary)CAUTION:
When replacing the ECM, a new ECM must be used...
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B133A-8F
AVM connection
(Camera image signal)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Camera image signal circuit (terminal 49)
Threshold
—
Diagnosis delay time
—
POSSIBLE CAUSE
Camera image signal circuit
Around view monitor control unit
AV control unit
FAIL-SAFECamera image is inoperative
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...