Nissan Murano: Power Window Control System :: Basic Inspection / System Initialization

Description

The initialization is necessary for normal operation of power window system If any of the following operations are performed:

• When control unit is replaced.

• Electric power supply to power window switch or motor is interrupted by blown fuse or disconnection and connection of the negative battery terminal.

• Removal and installation of regulator assembly.

• Power supply to the main power window and door lock/unlock switch or power window motor is cut off by the removal of battery terminal or if the battery fuse is blown.

• Disconnection and connection of main power window and door lock/unlock switch harness connector.

• Removal and installation of motor from regulator assembly.

• Operation of regulator assembly as an independent unit.

• Removal and installation of door glass.

• Removal and installation of door glass run.

The following specified operations can not be performed under the non-initialized condition:

• Auto-up operation

• Anti-pinch function

STEP 1

1. Ignition switch ON.

2. Open the window not less than half way.

3. Pull up on the power window switch to close the window completely. Continue to hold the power window switch up for 3 or more seconds.

4. Check that AUTO-UP function operates normally.

GO TO 2.

STEP 2

Check anti-pinch function. Refer to Work Procedure.

Inspection End.