Nissan Murano: Power Window Control System :: Basic Inspection / Additional Service When Removing Battery Negative Terminal
Description
When the negative battery terminal is disconnected, the initialization is necessary for normal operation of power window system.
CAUTION:
The following specified operations can not be performed under the non-initialized condition:
-
Auto-up operation
-
Anti-pinch function
Work Procedure
SYSTEM INITIALIZATION
Perform system initialization. Refer to Work Procedure.
>>
GO TO 2.
CHECK ANTI-PINCH FUNCTION
Check anti-pinch function. Refer to Work Procedure.
>>
Inspection End.
Work Flow
OVERALL SEQUENCEDETAILED FLOWINTERVIEW CUSTOMER
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred...
Description
The initialization is necessary for normal operation of power window system If any of the following operations are performed:
When control unit is replaced...
Other information:
Diagnosis Procedure
CHECK REAR POWER WINDOW SWITCH LH SERIAL LINK CIRCUIT
Check rear power window switch LH serial link circuit.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts...
The two radar sensors for the
BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog.
The blocked condition may also be caused
by objects such as ice, frost or dirt obstructing
the radar sensors...