Nissan Murano: Dtc/circuit Diagnosis / Right/left Switching Signal Circuit

Nissan Murano (Z52) 2015-2024 Service Manual / Cruise Control & Driver Assistance / Driver Assistance System :: Driver Assistance System / Dtc/circuit Diagnosis / Right/left Switching Signal Circuit

Work Procedure

CHECK CONNECTOR

Turn the ignition switch OFF.
Check the terminals and connectors of the side radar RH for damage, bend and short (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal or connector.

CHECK CONTINUITY OF RIGHT/LEFT SWITCHING SIGNAL CIRCUIT

Disconnect side radar RH connector.
Check continuity between side radar RH harness connector and ground.

Side radar RH		Ground	Continuity
Connector	Terminal
B466	3		Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair harness or connector.

Power Supply and Ground Circuit (lane Camera Unit)

Work Procedure CHECK FUSES Check that the following fuse is not blown. Signal name Fuse No. Ignition power supply 29(10A) Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit...

Warning System Buzzer

Component Function Check CHECK SYSTEM WARNING BUZZER CONSULT Turn the ignition switch ON. Select the active test item “ICC BUZZER” of “ICC/ADAS”...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B1315 Am/fm 1 Antenna

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1315–13 AM/FM 1 antenna (Radio antenna) [OPEN] Diagnosis condition When ignition switch is ON. Signal (terminal) ANT +B circuit between AV control unit and antenna base (terminal 67) Threshold – Diagnosis delay time 30 seconds or more B1315–11 [GND–SHORT] Diagnosis condition When ignition switch is ON...

Nissan Murano (Z52) 2015-2024 Service Manual: B2600-46 Config Error

DTC Description DTC DETECTION LOGIC DTC Trouble diagnosis (Trouble diagnosis contents) Detecting condition B2600-46 CONFIG ERROR (Configuration error) [CALIB/PRMTER MEMORY ERROR] When errors are detected in the configuration data stored in the 3CH CAN gateway...