Nissan Murano: Basic Inspection / Predictive Course Line Center Position Adjustment
Description
Adjust the center position of the predictive course line of the rear view monitor if it is shifted.
Work Procedure
DRIVING
Drive the vehicle straight ahead 100 m (328.1 ft) or more at a speed of 30 km/h (18.6 MPH) or more.
>>
End.
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing around view monitor control unit.Configuration has three functions as follows Function Description
READ CONFIGURATION
Reads the Nissan Murano vehicle configuration of current around view monitor control unit...
Description
Calibration must be performed after removing/replacing the cameras, removing parts (e.g. front grille, door mirror, and others) mounted on the cameras, or replacing the Around view monitor control unit...
Other information:
Diagnosis Procedure
Hydraulic pump electric power steering warning lamp does not turn OFF several seconds after engine is started.SELF DIAGNOSTIC RESULT
CONSULT
Select "Self Diagnostic Result" mode of "EPS/DAST 3".
Is any DTC detected?
YES>>
Check the DTC...
Component Function Check
CHECK DAYTIME RUNNING LIGHT OPERATION
CONSULT
Select “EXTERNAL LAMPS” in “Active Test” mode of “IPDM E/R”.
While operating the test items, check daytime running light operation.
TAIL
: Daytime running light ON
Off
: Daytime running light Off
Is the inspection result normal?
YES>>
Daytime running light relay circuit is normal...