Nissan Murano: System Description / On Board Diagnostic (obd) System
Description
This is an on board diagnosis system which records diagnosis information related to the exhaust gases. It detects malfunctions related to sensors and actuators. The malfunctions are indicated by means of the malfunction indicator lamp (MIL) and are stored as DTC in the ECU memory. The diagnosis information can be checked using a diagnosis tool (GST: Generic Scan Tool).
Function of OBD
The GST is connected to the diagnosis connector on the vehicle and communicates with the on-board control units to perform diagnosis. The diagnosis connector is the same as for CONSULT. Refer to Description.
System Description
SYSTEM DIAGRAMDESCRIPTION
Controls for improvement of the transmission efficiency by engaging the torque converter clutch in the torque converter and eliminating slip of the converter...
1 Trip Detection Diagnosis and 2 Trip Detection Diagnosis
NOTE:
“Start the engine and turn OFF the ignition switch after warm-up.” This is defined as 1 trip...
Other information:
Exploded View
1.
Blower unit
2.
Heating and cooling unit
Front
Removal and Installation
REMOVALRemove the heating and cooling unit assembly. Refer to Removal and Installation.
Disconnect the harness connector from the blower motor.
Remove the screw and then the blower unit from the heating and cooling unit assembly...
When replacing a wheel without the TPMS
such as the spare tire, the TPMS will not
function.
Observe the following precautions if the
TEMPORARY USE ONLY spare tire must be
used. Otherwise, your vehicle could be
damaged or involved in an accident:
WARNING
The spare tire should be used for
emergency use only...