Nissan Murano: Basic Inspection / Mixture Ratio Self-Learning Value Clear
This describes show to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.
For details, refer to Work Procedure.
START
With CONSULT
-
Start engine and warm it up to normal operating temperature.
-
Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode with CONSULT.
-
Clear mixture ratio self-learning value by touching “CLEAR”.
With GST
-
Start engine and warm it up to normal operating temperature.
-
Turn ignition switch OFF.
-
Disconnect mass air flow sensor harness connector.
-
Restart engine and let it idle for at least 5 seconds.
-
Stop engine and reconnect mass air flow sensor harness connector.
-
Select Service $03 with GST. Check that DTC P0102 is detected.
-
Select Service $04 with GST to erase the DTC P0102.
>>
END
Idle Air Volume Learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps engine idle speed within the specific range. It must be performed under the following conditions:
Each time the electric throttle control actuator or ECM is replaced...
Vin Registration
Description
VIN Registration is an operation to register VIN in ECM. It must be performed each time ECM is replaced.NOTE:
Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M)...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Telematics System
Symptom Table TELEMATICS SYSTEM Symptom Display icon Error message Possible cause Telematics operation not available. — Telematics unit is not connected. Perform self-diagnosis with CONSULT. Refer to CONSULT Function. The connection to the center failed...
Nissan Murano (Z52) 2015-2024 Service Manual: Working with Body Straightening Equipment
Use of Protectors Use of work clothes should be the same as for “PROTECTORS”. Refer to Protectors. Wear a safety helmet and safety shoes. When working under a Nissan Murano vehicle or when using a grinder, wear goggles. Precautions while Working To prevent danger in case the clamp slips or the panel breaks, be sure to apply a safety chain...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Checking engine oil level
- All-Wheel Drive (AWD) (if so equipped)
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
