Nissan Murano: Driver Controls / Mirrors :: Basic Inspection. Diagnosis and Repair Work Flow
OVERALL SEQUENCE
DETAILED FLOW
INTERVIEW CUSTOMER
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred.
>>
GO TO 2.
REPRODUCE THE MALFUNCTION
Reproduce the malfunction on the Nissan Murano vehicle that the customer describes.
Inspect the relation of the symptoms and the condition when the symptoms occur.
>>
GO TO 3.
SYMPTOM DIAGNOSIS
Use Symptom diagnosis from the symptom inspection result in step 2 and then identify where to start performing the diagnosis based on possible causes and symptoms.
>>
GO TO 4.
COMPONENT DIAGNOSIS
Perform the diagnosis with Component diagnosis of the applicable system.
>>
GO TO 5.
REPAIR OR REPLACE MALFUNCTIONING PART
Repair or replace the specified malfunctioning parts.
>>
GO TO 6.
PERFORM FINAL OPERATIONAL CHECK
Check that malfunctions are not reproduced when obtaining the malfunction information from the customer, referring to the symptom inspection result in step 2.
Are the malfunctions corrected?
YES>>Inspection End.
NO>>GO TO 3.
Component Parts. Door Mirror System (without Automatic Drive Positioner)
Component Parts Location
No. Component Function
1.
Auto anti-dazzling inside mirror
The sensor built inside the mirror detects the brightness of headlights of the Nissan Murano vehicle behind and automatically changes the light transmission to decrease the brightness...
Mirrors :: Dtc/circuit Diagnosis. Main Power Window and Door Mirror Switch
Component Inspection
NOTE:
If equipped with ADP, refer to Component Function Check (for select switch) or Component Function Check (for mirror switch)...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P062f Ecm
DTC Description DTC DETECTION LOGIC ECM back up system does not function properly. EEPROM (built-in microcomputer) system internal ECM does not function properly. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0603 ECM BACK UP/CIRCUIT [Internal Control Module Keep Alive Memory (KAM) Error] Diagnosis condition Ignition switch ON Signal (terminal) — Threshold ECM back up system does not function properly Diagnosis delay time — P062F CONTROL MODULE (Internal control module EEPROM error) Diagnosis condition Start engine and let it idle Signal (terminal) — Threshold EEPROM (built-in microcomputer) system internal ECM does not function properly Diagnosis delay time — POSSIBLE CAUSEDTC P0603 Harness or connectors [ECM power supply circuit is open or shorted...
Nissan Murano (Z52) 2015-2024 Service Manual: Service Data and Specifications (sds). Body Alignment
Body Center Marks Factory marks exist on certain parts of the body to indicate the vehicle center. When repairing the Nissan Murano vehicle frame (members, pillars, etc.) damaged in an accident the most accurate and effective repair will be achieved by using these marks together with body alignment specifications...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Shift lock release
- Checking engine oil level
- Turning the AEB system on/off
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
