Nissan Murano: Vehicle loading information / Measurement of weights

Nissan Murano (Z52) 2015-2024 Owners Manual / Technical and consumer information / Vehicle loading information / Measurement of weights

Secure loose items to prevent weight shifts that could affect the balance of your vehicle.When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the Gross Axle Weight Ratings (GAWR). The total of the axle loads should not exceed the Gross Vehicle Weight Rating (GVWR). These ratings are given on the vehicle certification label. If weight ratings are exceeded, move or remove items to bring all weights below the ratings.

Loading tips

The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label. Do not load the front and rear axle to the GAWR...

Towing a trailer

WARNING Overloading or improper loading of a trailer and its cargo can adversely affect vehicle handling, braking and performance and may lead to accidents...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: When Main Power Window and Door Lock/unlock Switch Is Operated

Diagnosis Procedure CHECK REAR POWER WINDOW SWITCH RH SERIAL LINK CIRCUIT Check rear power window switch RH serial link circuit. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts...

Nissan Murano (Z52) 2015-2024 Service Manual: P2297 Air Fuel Ratio Sensor 1

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2297 A/F SENSOR1 (B1) (O2 Sensor Out of Range During Deceleration Bank 1 Sensor 1) Diagnosis condition Engine run and fuel shut off Signal — Threshold Air fuel ratio(A/F) sensor 1 bank 1 is out of normal range Diagnosis delay time — POSSIBLE CAUSEAir fuel ratio(A/F) sensor 1 bank1FAIL-SAFENot applicableDTC CONFIRMATION PROCEDUREPRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test...