Nissan Murano: Road Wheels & Tires :: Dtc/circuit Diagnosis / Low Tire Pressure Warning Lamp
CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is placed ON.
Is the inspection result normal?
YES>>Inspection End.
NO>>Perform trouble diagnosis. Refer to Diagnosis Procedure.
BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace malfunctioning components.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)".
Is any DTC detected?
YES>>Check the DTC. Refer to DTC Index.
NO>>GO TO 3.
CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
CONSULT
-
Ignition switch ON.
CAUTION:
Never start the engine.
-
Select “Data Monitor” mode of "BCM(AIR PRESSURE MONITOR)".
-
Select “WARNING LAMP” in “Data Monitor”, and check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch ON.
Is the inspection result normal?
YES>>Check the combination meter. Refer to Diagnosis Procedure.
NO>>Replace the BCM. Refer to Removal and Installation.
C1769 Config Setting
DTC Description
NOTE:
The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Map Lamp Circuit
Description Controls the lamp (ground side) by PWM signal (duty) when the map lamp main switch is DOOR. Component Function Check CAUTION: Check the following items first: Battery saver output/power supply circuit Front room/map lamp assembly CHECK MAP LAMP CONTROL FUNCTION CONSULT Ignition switch ON...
Nissan Murano (Z52) 2015-2024 Service Manual: Vin Registration
Description VIN Registration is an operation to register VIN in ECM. It must be performed each time ECM is replaced.NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M). For details, refer to Work Procedure...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Memory storage function (key-link)
- System malfunction
- Vehicle Dynamic Control (VDC) OFF switch
- New on site
- Most important about car
Driver and passenger supplemental knee air bag
Driver’s side
The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.
Passenger’s side
