Nissan Murano: Heater & Air Conditioning System :: Removal and Installation / Liquid Tank

Condenser Pipe Assembly

Removal and Installation REMOVALDischarge the refrigerant. Refer to Recycle Refrigerant. Remove the core support cover. Refer to Exploded View. Remove the front grille...

Refrigerant Pressure Sensor

Removal and Installation REMOVALDischarge the refrigerant. Refer to Recycle Refrigerant. Remove the front bumper fascia assembly. Refer to Removal and Installation...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P1078 Evt Control Position Sensor

DTC Description DTC DETECTION LOGICAn excessively high or low voltage from the sensor is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1078 EXH TIM SEN/CIRC-B1 [Exhaust valve timing (EVT) control position sensor (bank 1) circuit] Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from EVT control position sensor to ECM Threshold An excessively high or low voltage from the sensor is sent to ECM Diagnosis delay time — P1084 EXH TIM SEN/CIRC-B2 [Exhaust valve timing (EVT) control position sensor (bank 2) circuit] Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from EVT control position sensor to ECM Threshold An excessively high or low voltage from the sensor is sent to ECM Diagnosis delay time — POSSIBLE CAUSEDTC P1078 Harness or connectors [EVT control position sensor (bank 1) circuit is open or shorted...

Nissan Murano (Z52) 2015-2024 Service Manual: Led Headlamp Operation Inspection

Work Procedure CHECK START In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp several times. Check that headlamp operates normally each time. In the cool LED status, turn headlamp ON, wait until headlamp enters the stable status (approximately 5 minutes after turning headlamp ON) and then check that headlamp operates normally without blinking or flickering...