Nissan Murano: Dtc/circuit Diagnosis / Led Headlamp

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Controls / Exterior Lighting System :: Led Headlamp / Dtc/circuit Diagnosis / Led Headlamp

Diagnosis Procedure

CHECK HEADLAMP (LO) GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect front combination lamp connector.

  3. Check continuity between front combination lamp harness connector and ground.

    Front combination lamp — Continuity
    Connector Terminal
    RH E243 5 Ground Yes
    LH E247

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness.

CHECK LED HEADLAMP CONTROL MODULE

Install the normal LED headlamp control module to the applicable headlamp. Check that the lighting switch is turned ON.

Is the headlamp turned ON?

YES>>

Replace LED headlamp control module. Refer to Removal and Installation.

NO>>

GO TO 3.

CHECK HEADLAMP

Install the normal applicable front combination lamp. Check that the headlamp is turned ON.

Is the headlamp turned ON?

YES>>

Replace front combination lamp. Refer to Removal and Installation.

NO>>

LED headlamp is normal. Check headlamp control system.

    Daytime Running Light Relay Circuit

    Component Function Check CHECK DAYTIME RUNNING LIGHT OPERATION CONSULT Select “EXTERNAL LAMPS” in “Active Test” mode of “IPDM E/R”. While operating the test items, check daytime running light operation...

    Parking Lamp Circuit

    Component Function Check CHECK PARKING LAMP OPERATION CONSULT Select “EXTERNAL LAMPS” in “Active Test” mode of “IPDM E/R”. While operating the test items, check that the parking lamp is turned ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Evap Vapor Lines


    Work Procedure CAUTION: Never use compressed air or a high pressure pump. Never exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: Do not start engine. Improper installation of EVAP service port adapter (commercial service tool) to the EVAP service port may cause a leakage...

    Nissan Murano (Z52) 2015-2024 Owners Manual: Using the panic alarm


    If you are near your vehicle and feel threatened, you may activate the panic alarm to call attention by pressing and holding the button on the Intelligent Key for longer than 1 second. The headlights will flash and the panic alarm will stay on for a period of time...

    Categories

    Unfastening the seat belts. Checking seat belt operation

    Unfastening the seat belts

    Nissan Murano. Unfastening the seat belts. Checking seat belt operation

    To unfasten the seat belt, press the button on the buckle Nissan Murano. Unfastening the seat belts. Checking seat belt operation. The seat belt automatically retracts.

    read more

     
    Copyright © 2026 www.nimurano.com