Nissan Murano: Basic Inspection / Inspection and Adjustment

Nissan Murano (Z52) 2015-2024 Service Manual / Electrical & Power Control / Body Control System :: Bcm / Basic Inspection / Inspection and Adjustment

Basic Inspection

..

Additional Service When Replacing Control Unit (bcm)

Description BEFORE REPLACEMENTWhen replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.CAUTION: When replacing the BCM, a new BCM must be used...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: U1010-49 Control Unit (can)


DTC Description CAN controller controls the communication of CAN communication signal and the error detection.DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition   U1010-49 CONTROL UNIT (CAN) [Control unit (CAN)] Diagnosis condition When engine is running When MAIN switch of ICC system is ON Signal (terminal) — Threshold If ADAS control unit detects malfunction by CAN controller initial diagnosis Diagnosis delay time 1 second or less POSSIBLE CAUSEADAS control unitFAIL-SAFEThe following systems are canceled: Automatic Emergency Braking (AEB) with pedestrian detection Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Lane Departure Warning (LDW) Intelligent Lane Intervention (I-LI) Blind Spot Warning (BSW) Rear Cross Traffic Alert (RCTA) Rear Automatic Braking (RAB) Traffic Sign Recognition (TSR) Intelligent Drive Alertness (I-DA) Confirmation Procedure DTC CONFIRMATION PROCEDUREPERFORM DTC CONFIRMATION PROCEDURE CONSULT Start the engine...

Nissan Murano (Z52) 2015-2024 Service Manual: Hood Hinge


Removal and Installation REMOVALRemove hood assembly. Refer to Removal and Installation. Remove front fender. Refer to Removal and Installation. Remove hood hinge bolts, and then remove hood hinge.INSTALLATIONInstallation is in the reverse order of removal...

Categories

Fuel gauge

Nissan Murano. Fuel gauge

The gauge indicates the approximate fuel level in the tank.

The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

read more

 
Copyright © 2026 www.nimurano.com