Nissan Murano: Glass & Window System :: Removal and Installation / Front Power Window Motor
Removal and Installation
REMOVAL
Remove front door glass regulator. Refer to Removal and Installation.
Remove screws (A) and front power window motor (1) from front door glass regulator (2).

INSTALLATION
Installation is in the reverse order of removal.
Exploded View
1.
Front door glass rubber run
2.
Front door
3.
Front door glass
4.
Front door glass rear run
5.
Front door power window motor
6...
Exploded View
1.
Rear door
2.
Rear door glass rubber run
3.
Rear door glass rear run
4.
Rear door glass corner finisher
5.
Rear door glass
6...
Other information:
Component Function Check
CHECK FUNCTION
CONSULT
Select the "HEAD LAMP(HI)" in "Active Test" mode of "BCM(THEFT ALM)".
Check headlamps operation.
Test item Description
HEAD LAMP (HI)
ON
Headlamps (Hi)
Light
OFF
Do not light
Is the inspection result normal?
YES>>
Inspection End...
DTC Description
DTC DETECTION LOGICEVAP canister vent control valve remains closed under specified driving conditions. DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0448
VENT CONTROL VALVE
(Evaporative emission system vent control circuit shorted)
Diagnosis condition
—
Signal (terminal)
—
Threshold
EVAP canister vent control valve remains closed under specified driving conditions
Diagnosis delay time
—
POSSIBLE CAUSE
EVAP canister vent control valve
EVAP control system pressure sensor and the circuit
Blocked rubber tube to EVAP canister vent control valve
EVAP canister is saturated with water
FAIL-SAFENot applicable
DTC Confirmation Procedure
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test...